InoGrip® uses the physical principle of the positive fit. Defined stamping produced by a holding and a stopper tooth makes the clamping jaw and the workpiece into one unit. The stopper tooth also provides an absolutely precise reference point.

Stamping is carried out separately in a stamping station with special stamping jaws and takes approx. 3-4 seconds. Work can continue on the lathe during the stamping process.


Thanks to InoGrip® …

  • workpiece deformation is reduced
  • higher true running precision is achieved
  • subsequent steps can be omitted
  • operation of the overall system is more stable
  • vibrations in the part are reduced
  • higher cutting speeds are achieved
  • only one set of clamping jaws is needed for scrubbing and finishing



Can't find what you're looking for?

Tel:+44 (0) 1844 208050

Fax:+44 (0) 1844 201699